Tell me what kind of things have you done on the social side?

1051

Can union be self referenced?

1245

How to get and log an error in angular 4?

862

How do societal biases get reflected in AI models?

11

Please send me rbi previous exam paper with ans for group B at aparna_majumder@ymail.com

2524

can you please tell me what the current rate of construction material and different construction labourers charge in bangalore ???

2032

Hi i am chinna reddy i had completed my b.tech(ECE)2010 passout. but still no job please if anyone help me and suggest me. my mailid:chinnareddy.be@gmail.com Thanks&Regards chinna

2104

can any body sand me previous exampapers of jr. engineer (mechanical)

1956

Circuit diagram of tube light without starter using electrical choke

4186

Draw a crankshaft and show the parts?

2225

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2231

What is the difference between GUI Testing,UI testing and Usability TEsting

2547

Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.

2179

placement paper samples of mspl company

1999

How Many Points include in Mat Calculation , what is the different bitween Gross Profit & Book Profits?

2566