what are the advantages and disadvantages of embedded compare to vlsi,dsp?
What is the coeffiencent Friction Angle between Steel and Ashphalt?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
while preparing insolvency account deficiency account is wich account? why we do not prepare it with general rules?
how can i use a nonsynchronized hashtable?
difference between tds and income tax (India)
Describe one or two of the most difficult challenges or rejections you?ve faced in the past and how you responded?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
why should we select you?
what is the voltage regulation for unity and zero power factor?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
Differentiate between documented and undocumented knowledge. 3. How is knowledge collected?