Answer / k.prakashchandra

This relay is usually employed in sub-station to avert sharp drop in frequency due to sudden additional load or drop in generating capacity . The setting may 0.3 Hz / sec. Under such condition ,this relay will open selected outgoing feeders to reduce the load

why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?

3 Answers   Greenesol Power Systems,

---

DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers  

---

Why attempration spray is used after hp heater?

5 Answers   CMJ Breweries Private Ltd., Thermax,

---

what is the condition of transformer parallel operation ?

3 Answers   BEDL,

---

LAPT working in alternator / generator

0 Answers   Power Plant,

---

What is creep, resilience.

2 Answers  

---

why do we use contro fluid tank (cft)in turbo generator area(tg) in power plant?

1 Answers   MPL,

---

why drum level is increased when one of the running coal elevations are suddenly tripped?

6 Answers   APGenco, Vedanta,

---

why do you consider yourself a suitable candidate for this position

0 Answers   Amazon, Eskom, Nabard,

---

why not maintain Ph 7.0 in Boiler because 7 Ph is not acidic and not basic.

4 Answers   Atlas Power,

---

what is actual CAL MODE & cal means?

2 Answers   GIPCL,

---

Why the steam Turbines are Designed Higher side compare to Alternator

1 Answers  

---