Answer / suraja

They are mainly used for two purposes 1-when turbine gets tripped msg stop valves and reheated stop valves will be closed in order to evacuate the steam from hp turbine it is used to dump into the condenser.
2-when turbine is being rolled these lines are used to maintain or increase steam parameters such as temperature and also it will allow a Drain condensate to condenser. It is taken from crh line to the condenser after unit synchronised it will close in auto those dump lines will be provided with spray valves.

Planning Engineer interview model question and answer

1 Answers   Tata Power,

---

What vibration parameters are monitored in a directly coupled single cylinder turbine and generator?

1 Answers  

---

why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?

3 Answers   Greenesol Power Systems,

---

What is Droop Control in Woodward?

3 Answers  

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

Difference between directional earth fault and non-directional earth fault

2 Answers  

---

How to calculate air to fuel ratio in boilers

1 Answers  

---

What is reheater protection based on what mft will be act on RH protection

2 Answers  

---

Calculating Seawater consumption for SWFGD system

1 Answers   Student,

---

What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?

1 Answers  

---

What is tripping relation between the turbine exhaust pressure and turbine last stage pressure....???

1 Answers   Jaypee,

---

what is the defenation of efficiency in the high pressor boiler? what is the formila of efficiency in the high pressor boiler?

3 Answers  

---