Answer / kc

first reduce the fairing of mill to reduce drum press if required take one elevation out .
else we can open E.R.V .

Answer / y v subba rao

Immediately we have to open the vent which was provided super heater outlet. The vent size should be such that it can draw sufficient steam from super heater to prevent overheating of coils due to starvation. We should keep it open till the minimum quantity of steam drawn by turbine. Mean while however drum safety will be closed due to pressure drop. Next we have proceed for line safety pressure setting.

Answer / anbu

If line safety was not lifted means better to open vent in that lines to reduce the pressure.

which safety valve will open first if steam is not been supplied to turbine.

3 Answers   Wartsila,

---

Why cold water is used for Boiler Hydro test

1 Answers  

---

what is under voltage protection 27

1 Answers   CLP, NCC,

---

what is restricted earth fault explain in details

0 Answers   Greenko, JSW,

---

thermal power plants in steam using inlet of turbine.inlet of turbine pressure and flow is same as boiler feedpump why not use direct to turbine?

6 Answers   IBPIL, JSW,

---

Is it not bad to bleed steam from turbine stages before utilizing its energy.

2 Answers  

---

what is the difference between kg/cm2 to MMWC

2 Answers   Ansaldo,

---

how shall you calculate PLF on the basis of percentage auxillary load factor

6 Answers  

---

what is absolute separator, how it works, what are the types in it

1 Answers  

---

how mony power plants in India

3 Answers  

---

Difference between islanding and house load operation.

2 Answers  

---

What is LB-SR.

0 Answers  

---