why expansion bellow is provided in between hopper and vessel
in ash handling plant?
Answers were Sorted based on User's Feedback
To provide isolation from vibrators & to reduce thermal stress between hopper and vessel.
| Is This Answer Correct ? | 13 Yes | 1 No |
Answer / jitendra sharma
The purpose of expansion below is to provide isolation from
vibrators which are mounted on the surface of the vessel.
Their are several no's of vibrators, to remove the fly ash
contents before it's temperature decreases to prevent
solidification of fly ash on the walls of vessel.
All u know that we remove the fly ash from boiler tubes and
APH with help of soot blowing.
| Is This Answer Correct ? | 8 Yes | 1 No |
under which situation or why restricted earth fault protection operates in out side its zone that is external fault
why airtel use + 24 volts and other operators use -48 volt
0 Answers ABC, Airtel, INDUS, Reliance,
what is the trip circuit supervision in an electrical meaning?
why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)
.What is drip and drain.
what is the relation between the grid voltage and generator voltage how to link up generator with grid
how many safeties should be present in boiler?what are they?
4 Answers DN, Nandi, Pump Technology, Siris, Thermax,
What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?
What will happen if id fan on boiler not functioning?.Can the Boiler run without id fan? What is the effect?
In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?
Is it not bad to bleed steam from turbine stages before utilizing its energy.
what is restricted earth fault explain in details
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)