What is A.T.T.?
Answers were Sorted based on User's Feedback
Answer / arunkumar
Air Tightness Test , which is normally carried out for Duct
Is This Answer Correct ? | 0 Yes | 0 No |
why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)
why Subcritical has 60% condenser capacity
voltage and frequency is equal but synchronisation not complete why?
how to differentiate between "ALL fuel lost" and "All Flame Lost" in Boiler MFT condition?
What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?
What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?
63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????
We know primary ,secondary air so, What is the work of Tertiary air in Thermal power plant
Why high pressure turbines are single flow
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
what is CT saturate?and which effect on CT after its saturate?
why we use reduction gear box to reduce turbine high rpm to 1500 rpm in small plant
3 Answers Maruti Suzuki, Sail,