if it is possible for the air conditioner to maintain the
temperature of 20 degree Celsius when the atmospheric
temperature is 10 degree celsius
Answers were Sorted based on User's Feedback
Answer / gary lanuza
It is not possible. The thermostat of ACU will remain open
if you set it to 20 deg. C while the incomning air from
outside is 10 deg.C. Therefore the compressor will not run
since air blown by the fan is colder than what is set by
the sensor - thermostat. You need to install other heating
device in order to maintain temperature hotter than the
ambient temp.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / amtee
Air conditioner has to be made worked as heat pump in this particular case.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / robin baby
It is possible in those air-conditioning systems with heat pump is also present. Actually in those systems it reverses the flow of refrigeration cycle with the help of a reverse valve. That means refrigerant flows from compressor to evaporator in this case
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / lakshmi niwas pathak
Few of the simulations result in less than 2 °C of
warming—near the low end of ... This pattern (statisticians
call it a "right-skewed distribution") suggests that if ...
system: the change in surface air temperature (ΔTs)
following a unit change in ..... central value C indicates
the maximum likelihood estimate in degrees Celsius and ...
| Is This Answer Correct ? | 1 Yes | 2 No |
What will cause if you run your engine in critical RPM continuously?
what is the difference b/w steam generator& boiler?
What are the methods of heat transfer?
2 Answers ABC Inc, RRB, Siemens,
What is more efficient between 2stroke & 4 stroke engine?
hey have you knw the GI sheet thickness as per gauge?
which cycle used in diesel engine
10 Answers Aster Teleservices,
What is the difference between gear motor and a stepper motor? Like i want to use gear motor for its excessive torque to move my robot. Can i use stepper motor instead?
can i apply for rrb with my provisional certificate..........
why entropy decreases with the increase in temperature?
4 Answers Bhel, GM General Motors,
There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?
What are reasons for poor machinability for IS 2062 steel
Hi i am going to attend the interview for BHEL. can you please help out in knowing about the area of preparation. I am apprearing for Executive trainee post. Please share your views on this. Thanks
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)