what is the difference between 1st angle and 3rd angle
Answers were Sorted based on User's Feedback
Answer / chaitanya pithawa
in 1st,view will come opposite side to the elevation i.e.
plan will come below to the elevation and rhs view will come
left to elevation when in 3rd angle, plan will come above
the elevation and rhs view will come righ side to the elevation.
|Is This Answer Correct ?||26 Yes||9 No|
Answer / pankaj kumar (sai polytechnic
in the first angle projection the front view is on top of the bottom view,where as in third angle projection the bottom view is held top of the front view fig.
|Is This Answer Correct ?||8 Yes||0 No|
Answer / arun kumar
In 1st angle, Side View projection will be on right side of
Elevation, whereas in 2nd angle,Side view is on left side
|Is This Answer Correct ?||3 Yes||10 No|
Q : How to calculate cooling water pumps head, do I need to consider static head and frictional loss of the pipe with high elevation? I mean to say is discharge pipe branches to several elevations and joins to the cooling water return line. The highest elevation pipe goes to a heat exchanger at (xx) psi inlet pressure. Should I consider only pump discharge header and this piping for head calculations? How about frictional losses in return pipe? Pressure recovered in return piping is good enough to make it back to the cooling tower?
which case we find maximum pressure & flow in centrifugal pump - circular casing or volute casing?
Deisel engine is designed to generate 10 MW at 50 deg c, can we expect more power from it at 30 deg c.
How do you convert feet into square feet?
will I find the mechanical engineering interview question for asian paints?
sir i want model and previous year question paper of RRB. please send it to my mail id. im a mechanical engg.
• Are you willing to work overtime? Nights? Weekends?
What is the difference between scavenging and supercharging ?
what is the temperature of space ?
Upper piston ring is compression ring?
distance between the power generation and the distribution to the application is fixed or vary
should cutouts made in main header of metal ducting be deducted from duct measurement.