What is the cause of AHU motor V-Belt wornout

Question Posted / syed.yaseen

1 Answers
4960 Views
I also Faced
E-Mail Answers

What is the cause of AHU motor V-Belt wornout..

Answer / murali

V-BELTS WORNOUTS ONLY IF THE IMPROPER ALLIGHNMENT BETWEEN
MOTOR PULLEY & BLOWER PULLEY.

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Mechanical Engineering Interview Questions

Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.

0 Answers ONGC, TATA,

WHY DO DEAD BODIES SAIL ON WATER WHERE AS A HUMAN BEING GET DROWNED?

1 Answers

why does polytropic efficiency of a compressor decrease with increasing flow rate ?

0 Answers L&T, ONGC,

How much is the specific fuel consumption of an average diesel engine?

1 Answers RRB,

more base coross sectonal area object can stand steadly than a les cross section why

1 Answers

what the raw mill

1 Answers

what is fullform of ge 9ea gas turbine

0 Answers Qatar Petroleums,

How is the gear ratio calculated?

0 Answers

What is pour point?

1 Answers RRB,

What is Temperature ?

5 Answers Dr Reddys, Reddy Labs,

i want all the questions asked interview in tech mahindra also the written exam papers in tech mahindra what is the future in the mahindra for the fresheres in mechanical? you future visiting area for campus

3 Answers MAHINDRA, Tech Mahindra,

boils laws

5 Answers

For more Mechanical Engineering Interview Questions Click Here