Answer / tanmay kumar

generally magnetic balance test was done in transformers to know the ratio that means to check its rating whether it is giving the output or not as per the rating,,,in case of magnetic balance test the voltage feeded at the primary side always i.e l.v side and the secondary side is at no load i.e open ckted and a tongue tester is used to measure the amount of flowing current from primary to secondary.

Answer / k.prakashchandra

To limit the short circuit current

What would be the steps and parameters in case if a fault occurs in transmission line at a distance far from the generating station?

0 Answers  

---

The cable area of cross section is 185 sq mm. How to convert this to the diameter.

7 Answers   Syscon,

---

in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?

0 Answers   Elicon,

---

if voltage in transmission line more than current will be more or less,if less what about the Ohm's law

2 Answers  

---

how to check a transformer insulation?

3 Answers   Kirloskar, Kirloskar Chillers,

---

why zero sequence impedance measurement is not applicable for single phase GT

0 Answers  

---

why earth hole size is biggest in socket point.

5 Answers  

---

if only one generator is running in droop mode parrallel with grid and suddenly grid breaker off what will happen? It will trip o/u freq or stay as it is? (urgent)

10 Answers  

---

How to calculate the average power factor in 3 phase unbalanced system

5 Answers   Bhel, MacLellan,

---

does frequency affects the load? if yes elaborate it.

1 Answers  

---

WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.

0 Answers  

---

i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.

0 Answers  

---