Answer / kanaksinh

we conect 1000v mager between ph-ph & ph-earth and check
valu its more then 5mohm its ok

Answer / kamalkumar.s

To check the use of megger (Phase to Phase) and (Phase To
Earth) the range more then 5 Ohms its k.Below 5 Ohms to
check the cable and correct it.

Answer / sanjay kumar jain

we will check the Transformer PI value by Megger. It should
be <1.25 then transformer insulation isfair

Whot is the braking capacity for MCCB. How we select different braking capacity.

1 Answers  

---

Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.

0 Answers   CB&I Lummus,

---

WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.

0 Answers  

---

1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?

0 Answers  

---

what is the use of buchzloys relay?

2 Answers  

---

WHAT IS THESETTING CALCULATION FOR THE RELAY?

1 Answers  

---

What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.

0 Answers  

---

when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//

0 Answers  

---

the transient state stability limit of a system wherin power is transmitted throgh a double transmission line is (a)equal to steady state stability limit (b)more than its steady state stability limit (c)less than than its steady state stability limit (d)equal to its dynamic stability limit

1 Answers  

---

what is cogging? how it can be controlled?

1 Answers   HCL,

---

what is a core company? why should we join a core company?

1 Answers  

---

wat is the difference between BE &BTECH.

8 Answers  

---