Answer / jai

1,Confirm the function of SOV,if its OK,
2.Measure the vlotage across the SOV..it should be 24 VOlt.
3.If it is not matching with supply voltage measure the
coil resisitence of SOV...resistence should equal to
manufacturere resistence value

Answer / mudassir

check the fuse in the MR room which is in cabinet.andd the
field to mr continuity

Name different parts of a pressure gauge.

0 Answers  

---

how checking is done in fiber optic cable? explain the working of RTU?

5 Answers   PSU,

---

How to calibrate radar lt type transmitter

1 Answers   NTPC,

---

Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72

0 Answers  

---

What is Electrical Runout & Mechanical Runout in Vibration measurement.

1 Answers  

---

how to calibrate level transmitter

2 Answers   Reliance,

---

How can I make calculation for Install level transmitter (DP) for open tank and cloes tank?

1 Answers   Petrofac,

---

In control engg. : Differences b/w 1st order & 2nd order system, graphically & theoretically ?

0 Answers  

---

-200mmwc to 500mmwc range transmitter have there 4mA is -200 and 20mA is 500.what is the range in 12mA?

5 Answers   NCC,

---

Describe the basis on which alarms should be generated and how their associated priority is determined

3 Answers  

---

Name and describe at least 4 status indicators, typically found on a PLC

2 Answers  

---

GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.

7 Answers   DVC,

---