In control engg. : Differences b/w 1st order & 2nd order
system, graphically & theoretically ?
No Answer is Posted For this Question
Be the First to Post Answer
what is piezoelectric transducer?give an example in power plant n state its principle?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
how to calibrate pressure gauge(we can not able to fixed by pointer screw adjustment and pointer re fixing method)
what is difference between OP AMP and differential amplifier?
Why we use 250 ohm resistor in series with HART protocol communication?
13 Answers Chemtrols, Instec, Sabic,
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
in mass flow meter what is drive friquancy ?
how we convert Mili ampere to temp txt,level txt,flow txt,pressure txt range value
how the flow rate is measured from a pipe with the help of pressure?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what is difference between RTD and Thermocouple?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)