Answer / r.murugan

STATUS INDICATION:

1. ON STATUS / 2.OFF STATUS / 3. DISTRUBANCE STATUS / 4.FAULT

Answer / aswin

Start indication
Stop indication
Local/remote indication
Trip indication
Swgr permit available/mcc disturb

what is the significance of hook up

3 Answers  

---

how to calibrate 0- 150 psi presure gauge by dead weght tester

0 Answers  

---

Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?

4 Answers   Ecil,

---

what is the input to be given in digital flow meter during the the calibration time?

0 Answers   ONGC,

---

how can i calibrate E & h make conductivity transmiter . unit : mocro siemens Range :0 to 100 micro siemens sensor : capacitive type

1 Answers  

---

Wht should be the ratio of natural frequency (Fn) to wake frequency (Fw) and wht if goes above the rato limit?

2 Answers  

---

Where can i take training in intools software for Instrumentation design??

9 Answers  

---

Control valve Flow characteristic. How the equal percentege curve form?

5 Answers  

---

can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.

0 Answers   Bhavini,

---

What is the differerence between hysterisis and linearity.

0 Answers   CCIE,

---

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers   GMR,

---

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers  

---