Answer / abhi

Mechanical Runout :– An error in measuring the position of the shaft centerline with a displacement probe that is caused by out-of-roundness and surface imperfections.
Electrical Runout :– An error signal that occurs in eddy current displacement measurements when shaft surface conductivity varies.

What are the different type of instrument used in cement industry with uses

2 Answers   Lafarge,

---

What is eddy current? Describe the operating principle of proximity probe.

0 Answers  

---

what is burner management system?

2 Answers   Alstom,

---

why we are using perforted cable tray for control cable and ladder tray for power cable

1 Answers  

---

Emergency Shutdown Systems/ Plant Shutdown System.

0 Answers   CCIE,

---

Paper Details: company -- Hindustan Copper Limited post -- GET 2008 Date -- 03.08.2008 Dept.-- Electronics?Instrumentation Aptitude -- 70 Technical-- 80 Total Time -- 2hr 30min I have listed the question I could able to remember 1. BCD equivalent of 43 2. value of K for stability of a system from a given equation 3. transformer connection for darlington connection 4. damping of balastic galvanometer 5. advantage of chart-pen recorder over CRo 6. CRO - how to change bandwidth 7. questions on CRO construction 8. reverse saturation current of si diode 9. advantage of wire wound resistance over carbon resistance 10. core material for a small coil 11. max fanout-- TTL/ECL/CMOS/MOS 12. component of resistance of monolithic IC 13. functions of capacitors in multivibrators 14. to change a sawtooth signal into a square wave we use-- schmit trigger/ schottkey diode/ zener diode 15. relation b/w á & â in transistor ckt 16. function of SiO2 layer in fabrication 17. 3 questions on ODD MAN OUT

2 Answers   HCL, L&T,

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers  

---

Which is your favourite subject & explain any one topic of it.

0 Answers   L&T,

---

Range 8 Kg/cm2, alarm to be set at 2Kg/cm2, at wat pressure reciever switch to be calibrated? justify the ans?

3 Answers  

---

what is three element in thermal boiler

9 Answers  

---

i want to measure temp of hot sand(welding flux) in closed chamber(around 150 deg C).Which is better thermocouple or thermometer?

1 Answers  

---

what is skin thermocouple?

3 Answers  

---