Calculate the maximum pressure drop that can be allowed to occur across a cont

Calculate the maximum pressure drop that can be allowed to
occur across a control valve, so that we can prevent
cavitation / flashing from occurring. Use the following
formula:

Δ P allow = Km (P1 – PvapourA)

where,
Δ P allow - the maximum allowable differential pressure for
sizing purposes, or terminal pressure drop;
Km- the valve recovery coefficient from the manufacturer’s
catalogue;
P1 - absolute inlet fluid pressure;
PvapourA - absolute fluid vapour pressure at the inlet
temperature;

Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g),
PvapourA = 4 kPa, KM = 0.72

Question Posted / slyabi

0 Answers
2190 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers

How hart protocol can be connected with control valves?

0 Answers

In field side transmitter voltage droping here no loose connection then what will happen?

2 Answers Edac,

diff between dead wt calibrator n pressue comparator?

4 Answers Invensys,

What is the working principle of oxygen analyzers(zirconium oxide type) used in CFBC boilers?

3 Answers Bajaj, Kohinoor, Wartsila,

what is the characteristics of control valve?

7 Answers

What means zero and span in transmitter callibration.

8 Answers Bajaj, Wartsila,

in yokogawa prosef rd safety PLC how to data send frome local SCS to other SCS and other FCS

2 Answers

how to check diode wheather it is working or not by using multimeter?

3 Answers

What is input and output of plc & dcs

2 Answers

hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....

0 Answers

plz tell me clearly about PID.."when v have to change I value,D value,GAIN??

0 Answers

For more Instrumentation Interview Questions Click Here