Answer / dfgds

Number flip flops requires depends on following formula.

2^(N-1)<number required <2^N
so to count 16 numbers the required flip flops are
4.(considering 0 as first number to 15 as last number).

Answer / arindam

it 16bit counter not 16 state counter......so ans is
16....not 4

Answer / jatinderpal singh

the no of ff is for 16 bit counter is 4
boz...
to get 16 bit counter we take 2raise to power 4 ...or genrally
2 raise to power n where n represents number of ff,,

Answer / jg

The question asks for 16 bit counter, NOT 16 states
counter. Therefore, the number of flip-flops required is
16.

Answer / thowsif

One Filp Flops can used for Count of 4 Bits,

So For 16 Bits,total no of F/F Required is 16/4=4 No's.

Answer / tanvi

2 to the power n..gives the number of the flip flops

Answer / prashant

according to formula
2^n<=N
where n is the power and N is no. of bit for a counter u required.

this implies u need 4 flip flops...

Answer / narasimhan

4 flipflops

Answer / narasimhan

no.of states =2^n=no.flipflops(n);so 4 fp can be used to
make 4 bit ripple counter

Answer / prosenjit majumder

To get 16 bit counter you need 16 no. of flip-flops .

what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).

0 Answers  

if we give 60 hz single phase supply to the transformer used in europe , than what will happen

0 Answers   Core Logic,

why do harmonics generata?

1 Answers  

In radial network the source is fed from 1 end both ends at central

0 Answers  

how can a race around condition be eliminated using master slave flipflop?????

3 Answers  

Electrical Diagram of Electric Arc Furance from transformer to Furances

1 Answers  

There are two nos of 33Kv/11Kv 5MVA transformers conecting through HT cable from substation having metering at substation itself.One transformer used at a time another remains stand by.Further 11 nos of 11Kv/440V transformers are attached on it and each transformer is having its own Power factor correction panel.Now one 33/11Kv transformer at no load condition/Stand by condition is having power factor in leading side upto 0.21 and while when another tranformer at same situation have power factor in lagging 0.42. Now one thing is clear that transformer one is having 1.5 Km long 33kv cable due to that PF goes in leading side and another is having only 250 mtr length remains him lagging. Now i want to know that how i can maintain the Power factor at no load/ stand by position though both are behaving in seperate manner.

1 Answers  

what is meant by GD2 ?

1 Answers   Kirloskar,

if a bird sits on the service wire it didn't get shock then why the human get shock when he touches it(assume that human is not on the ground and any object i.e. in space)?

5 Answers  

Differentiate between ideal and non ideal current sources?

0 Answers  

what is gridrotor resistance starter

0 Answers  

List of equipments required foe industrial repair lab.

0 Answers