Interested to Buy Any Domain ? << Click Here >> for more details...
How many no of flip-flops are required to get 16 bit counter
- 10 Answers
- 26812 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / thowsif
One Filp Flops can used for Count of 4 Bits,
So For 16 Bits,total no of F/F Required is 16/4=4 No's.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What are reasond for high wattage in single phase induction motors
what are carbondioxide and dcp used in fire extinguishers
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
why impedance relay is used for medium transmission line protection
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
In dc ckt. 24v or 110v, which one is more efficient and why?
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
