Answer / saravanans

hai i am saravanan from madurai ( west masi street )

answer:
below one ohm should be maintain in neutral earthing.

Answer / mahesh sali

for solid earthing it will come around - 5 ohms

for resistive earthing the value being 1 to 2 ohms

for reactance earthing the above value will come down
around , it will be les than 1 ohm ,


thank u

Answer / rahul j

it's near to 1 ohm.

I have two power supply.a)govt. power b)Captive power.3 phase load connected inside factory.when source change govt. source to captive some motor rotate reverse. Is phase sequence changes when if off & on?If I off generator & on it again is it possible to get changed phase sequence??

4 Answers   ABB,

---

Regarding units, for voltage we are denoting Volts as V but in case of current we are not denoting Ampere as A instead as I..Why..? Any technical reason for this..?

1 Answers  

---

What is the meaning of maximum demand

21 Answers   MN Dastur,

---

In which iron losses is higher induction motor /transformer

1 Answers  

---

What is the high series capacitance winding on high voltage power transformer ?

0 Answers  

---

How much dc volt applied in cathodic protection system?

0 Answers  

---

EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?

0 Answers  

---

what is the reason of current flow in nutral although load is balanced (three phase equal current)

3 Answers  

---

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers  

---

what is the function of rccb how it diffrentiate between elcb

1 Answers  

---

why the the electrical machine coil are damage ? How to prevent it?

2 Answers  

---

If a motor of 30KW rating &200 mtrs distance from feeder give me the cable size selection calculation?

0 Answers  

---