Answer / moti rgpv

IN SYNCHRONOUS MACHINE THERE R INTER LOCK B/W ROTOR AND
STATOR POLES.
IF SUDDEN LOAD CHANGE THEN THIS LOCKING MISMACH.
THIS IS POLE SLIP

Answer / sharath

Rotor and stator field of a synchronous generator run at same speed, if due to any disturbance , mismatch in the speed of rotor and stator occurs then pole slipping is initiated.

Answer / virendra

As the three phase power is givan to the motor the
mangnatic field is devloped in the winding & it starts
rotating at synchronus speed. the mangnatic field devloed
is cut by the rotor winding & force is applied on to the
winding & rotor srats rotating. generally rotor should run
with the speed of ,amgnatic field but due to load generally
it does not happen & rotor speed is just legs to the speed
of mangnatic field this diffrence is called a pole slip

Answer / u.chandarasekar

pole s;lip islip that is s when the lighting pole is not
fixing properly that time the pole is pole slip
what is this non sence question

when u are given a timer,push buttons and contactor, how do i practically make a star delta control circuit and a direct online control circuit?

1 Answers  

---

What is the difference between Ac curent & DC current

2 Answers   Juniper Networks,

---

1 KW = how many HP

3 Answers  

---

what is maximum demand.

9 Answers   HP,

---

During a temperature rise test of a bus duct, it is fed with 415 volts at 2000 amperes. Why dont we get an electric shock if we touch the bus bars?

7 Answers   ABB, SDBL,

---

How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?

0 Answers   Reliance,

---

How many earthings are required for commissioning the Transformer?

14 Answers   Dalmia Group, HSL,

---

Differentiate between ideal and non ideal current sources?

0 Answers  

---

what percentage of marks in B-TECH is needed for section engineering exam

1 Answers   RRB,

---

how to increase or decrease speed in DC shunt motor by DC convertor

0 Answers  

---

in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?

0 Answers  

---

What is order of the system?

0 Answers  

---