Answer / sanjay sharma

it is % of rated primary voltage which require to establish
sufficient flux to produce full load current in short
circuited secondary, it is used while load loss test on
transformer.

Answer / hussain

Impedance voltage of a transformer is the measured voltage apply at primary winding while the secondary winding terminals of the transformer is short circuited and is increased gradually from zero till reach to full load current flows in the Primary. This voltage is much smaller than the transformer primary nominal voltage.

Answer / ahmed

Impedanc voltage value depends on the design of the transformer. decreasing this value means good transformer materials and vice versa.

Answer / istván galamb

It is the drop (ε) of a transformer:

ε = Usc / Un x 100 = In / Isc x 100

Un = nominated primer voltage

In = nominated secunder current

USc = primer voltage to obtain the In, when the secunder
side is short cicuited

Isc = secunder short circuited current

Answer / ekanadam patlavath

simply is Impedance voltage of a transformer is the
voltage drop in transformer,

voltage drop in transfermer,from primary to secondry
voltage. this i called impedence voltage of transfoermer

Answer / rvg

Impedencce voltage is nothing but self induced voltage in
reverse direction acting against the applied voltage( across
primary)
That is why after switching ON, the current intake reduces.

two bulbs of 100w and 40w respectively connected in paralel across a 230v supply.which bulb will glow bright and why?

4 Answers  

how to calculate the output power of vfd , please help me.

1 Answers  

in our 6.6kv motor feeder[it is having two sources from Bus A&B] earth fault relay is acting, we checked CBCT connection and cable meggerd values found very good still earth fault acting during first two are three start after that it will hold. please clarify what was the reason. if same motor is starting from other Bus-A it will start.

1 Answers   Gasal, Voltech,

A 30KW motor running at 1450 rpm draws 56A, how would you determine if this is correct or not?

3 Answers  

3 Core x 35 Sqmm Cable (How we measure 35Sqmm)

4 Answers   Alpha Star, Brother,

What is the diff. between single compression and double compression gland

0 Answers   ASL,

I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA

1 Answers  

to improve the existing power factor whether capacitors have to be added in series or parallel.and why

3 Answers  

In 3 phase induction motor 1hp current rating is 1.5 amps constant ? is correct or not ?

4 Answers   TATA,

if 50hz transformer is required to be run on 50% frequency what needs to be done???????????

6 Answers   century,

How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).

0 Answers   ONGC,

What are the types of circuit breakers ?

6 Answers   Genco, Super Max,