I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND

I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN
POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL.
1-IS BETTER WE USE CABLE?
2-IS BETTER WE USE BUS DUCT?
my transformer rate power is 2500KVA

Question Posted / hossein.arabian

2 Answers
3379 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION P..

Answer / mohamed

BETTER WE USE BUS DUCT BECAUSE :1-LOW VOLTAGE REACH TO 0
2- BUS DUCT WE HAVE BUS BAR WHICH CAN PROVIDED MORE CAURRENT
3-MORE FLEXIBILTITY

Is This Answer Correct ?

3 Yes

1 No

I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION P..

Answer / Kaushal Pratap Singh

For high power applications like a 2500KVA transformer, it's recommended to use bus ducts instead of cables. Bus ducts are more efficient and can handle higher currents due to their larger cross-sectional area. However, the specific choice between cable and bus duct depends on factors such as cost, installation requirements, and available space.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side

1 Answers

Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.

1 Answers Pride Hotels,

What is duty cycle for HT motors? How many start permitted if mentioned as 01 for hot and 02 for cold per duty cycle?

1 Answers GVK,

How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.

1 Answers Cesco,

can someone explain that how the speed of the protection system affects the fault level calculation?

1 Answers

What is the difference between MCB and Earth MCB? What is the working principal of MCB?

2 Answers

how to find motors H.P. whout any rating? (only give you a motor and multimeter)

4 Answers L&T,

What is the use of iron core in a transformer?

1 Answers

How would you supply power to a village which is very far from a sub-station and has only a 11k?

4 Answers Power Grid,

how to calculate capacitor bank value to maintain unity power factor plz xplain with some suitable xample?

4 Answers

how the arcing is made in ac electric arc furnace? ( between the three electrodes in any sequences or between the electrode & the charge(steel))

1 Answers

If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?

1 Answers REM Electromech Pvt Ltd,

For more Electrical Engineering Interview Questions Click Here