Interested to Buy Any Domain ? << Click Here >> for more details...
3. What is Impedance Voltage in Transformer?
- 16 Answers
- 113902 Views
- KESC, L&T, Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / ahmed
Impedanc voltage value depends on the design of the transformer. decreasing this value means good transformer materials and vice versa.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the purpose of using busbar mounting fuse?
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
why capacitive load is not used in routine life????any reason is there ??????
What are the raitings of Mcb,mccb and Acb in detail ??
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is the reactive power what is the use of it in system
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
how to calculate cooling requirement of datacentre from electrical load?
Can a generator runs after getting 1st stator earth fault.
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
