what is difference between profibus and field bus?
Answer / niranjan
Fieldbus (or field bus) is the name of a family of industrial computer network protocols used for real-time distributed control, now standardized as IEC 61158.
PROFIBUS (Process Field Bus) is a standard for field bus communication in automation technology.
The Profibus in his Process versión (Profibus PA) is two wire (Twisted pair) for data and power.
fieldbus foundation is only for process (Mainly for instruments), Profibus is for process and automation (instruments, drives, I/O, motor controllers to PLC, PLC to PLC etc.).
|Is This Answer Correct ?||15 Yes||1 No|
1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?
What is 3 selection available when configure the burnout protection for controller
what is the input of digital RPM indicator during the calibration time?
In which principle Woodward Governor 505 work in power plant? What are the input of Woodward governor 505
What is difference between magnetic flow transmitter & Electromagnetic flow transmitter?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Why DP level transmitter preferred for closed vessels and Radar level transmitter for open tanks??
What is the loop calibration? Which instrument used to loop calibration and how?
generally for transmitter we are giving supply 24vlts?but we are getting output 4-20ma ? how it is possible? is there any operation inside the tx?pls give complete information?
what is written on orifice plate?
Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?
how can we caliberate interface level troll