Answer / ergajjarchintan86

GWR
1.high frequency radar impulses
2.contact measurement
3.Exceptional
Performs well independent of process conditions.
4.extreme temp and pressure do not effect device performance
NGWR
1.microwave pulses
2.non contact measurement
3.Acceptable
Performance is based on strength of reflection and surface coditions
4.air space determines measurement accuracy.

Please send the all question with answer related for interview.

1 Answers  

---

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers  

---

What is loop1 and loop2 in MTS LT?

0 Answers  

---

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the

2 Answers  

---

how to calibrate steam control valve in steam turbine

0 Answers  

---

what is the meaning of reverse action and forward action of control valve...

9 Answers   Honeywell, Yokogawa,

---

how can we calibrate the differential pressure transmitter by using HART communicator

8 Answers   Hindalco,

---

what is mean by hot loop and cold loop testing, whts different between both

2 Answers   Honeywell, PDO,

---

Using your own examples solve a problem involving normal table. (experimental method and analysis)

0 Answers  

---

In most process, speed of motor controlled by control system with a reference pot . Now if i start & it becomes uncontrollable, i.e.gets directly start & stop after certain time.Then which reasons can make such problem? can motor may be faulty?how?

3 Answers   Siemens,

---

suppose there is gas flow meter I want to know weather meter calibration is done at high pressure or low pressure? pls justify.

2 Answers   Siemens,

---

how to control motor load with rpm or vfd

1 Answers  

---