Can neutral line also be use as a earthting for
distribution transformer, or we need separate earthing pit
forh the transformer?
Answer / ullas
in the distribution transformer the secondary star side
common point is earthed and taken it as a neutral terminal.
this neutral is earthed 4 place i one mile., in order to
keep the potential as zero volt..
there are so many distribution systems in india.
take the case of kerala, my state.
here we are using the TNCS System.
here phase line and neutral line are given to the consumer
by the supplier. the consumer shall provide an earth pit
for earthing his equipments.
in tamilnadu the TNEB provide additional earth line with
phase and neutral.
| Is This Answer Correct ? | 7 Yes | 0 No |
how to calculate knee point voltage of current transformer?
21 Answers Bhel, Bhilai, Jackson,
How many types of lightings are there
THERMAL CAPACITANCE IS MEASURED IN..................................................
What is the rating of your capacitor bank at your company.
36 Answers Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory,
I had attend the ITC (Indian Tobacco Company) interview (For Electrical maintanance).There they was conducted me a written test.And I was passed in that.Now They are going to conduct a Practical Interview in next round.Please help me what practical test they will ask............?
What will be the capcity of 3 phase DG set require for 25 KVA single phase lighting load?
why is used for starters for staring motors?
What will be the full load current of 60KVA UPS. Suggest for this formula.
what is the diffrence between earth and neutral.
If a HV Underground Cable (13.8KV) is layed in the ground below 1.5 Mtrs and any building construction is done on the Cable route. IS this allowable or Not? What should be the clearance. As per ISO construction on HV cable route is safe or Not? Why? Can any body suggest the site for my question?
suppose we using 3 phase motor of 440 v means what range of C.T. is require for measuring current , the rating of motor is 1HP ?
How to find the length of a Xlpe cable required to transmit 3mva load at 22kv.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)