Answer / bharat khatri

Pile is relatively long & slender structural member usd to
transmit foundation load through soil o low bearing cpacity
to deeper strate of high bearing capacity

Answer / priyank pal

pile foundation is the foundation which provide at that
place where the ordinary type of fondation is not to be
applicable because the upper strata is not able to sustain
the wait and the heavy weight are present there due to live
or dead load of structure so at that place pile foundation
are provided to transfer the load at the the greater deapth
where the harder strata present

Answer / sagnik

Pile foundation is a type of deep foundation where piles are sunk deep into the ground at depths upto 30mtrs or more also.
The main reasons for such a foundation type can be i)very high loads that a single footing or pile can bear alone or ii) due to low bearing capacity of the soil.
The piles bear loads both by the frictions gained from their surface and also due to bearing capacity of the soil at the particular depth.

Answer / m.mahesh

Pile foundation is one of the
typs of deep foudaton.it is an
elemnt of constrction usd as
fundton.it may be driven in
ground verticaly or with sm
inclinaton to transfr the load
safly.typs-undr
reamd,timbr,cmposte,stel,

Answer / swarna prava nayak

pile foundation is a type of foundation which provides a common solution to all difficult foundation site problem.

Answer / k7

IT IS A PART OF STRUCTURE CARRY A LOAD TO TRANSFER THE
COLUMUN

Answer / manoj

pile foundation is a type of deep foundation which is
prefered in case of encounter of upper soil strata of lower
bearing capacity.In order to transfer the loads of the
superstructure to a strata of high bearing capacity deep
below the ground such as rock strata pile foundation is
used.

Answer / snehashish basu

Pile is that type of Deep foundation structure constructed
to carry largeer amount of load in contrary to any shallow
depth foundation of equivalent area with minor settlement
in future.

Answer / badr khalaf ambusaidi

pile foundation is one of deep foundation type
we used alwayse this type when the depth of foundation (Df)
more than width of foundation (B) that in ganarl
but the most of stander call we used pile foundation when
the depth (Df) more than 3m
it is like thin colomuns and the transfe the load by three
tybe
1 end bearing of piles
2 skin friction
3 composit method

Answer / chowdary

pile foundation is a tipe of deep foundation
1)load transmit to be super strcture to soile
2)it use iow bering capasitetey soil
3)it use chiminey

Difference between tension and compression zone

3 Answers  

what is the different betweem expansion and construction joints

2 Answers  

What is the mix propotion of M10,M15,M20,M25,M30,M40,M50.M60 cement content,aggrigate,sand and water ratio.

0 Answers   L&T,

How to build the floor to ceiling bookcase?

0 Answers  

How to calculate quantity of plum masonry in 1:3:7

0 Answers  

why construction joint in the slab should be l/3 of span? what's the technical reason for that?

1 Answers  

Define a polyline?

0 Answers  

How to calculate the crank rod in slab

0 Answers   Bridge and Roof, Krishna Constructions,

what are the functions of wall

2 Answers   ATS, Gammon,

How to calculate bottom width of landing in a staircase

1 Answers   Tata Steel Limited,

why either no or minimum shear reinforcement is provided in case of slabs?

6 Answers  

The horizontal distance between parallel main reinforcements in RC slab shall not be more than

1 Answers   BEL, BSL, L&T, Mrkr Constructions,