Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sagnik
Pile foundation is a type of deep foundation where piles are sunk deep into the ground at depths upto 30mtrs or more also.
The main reasons for such a foundation type can be i)very high loads that a single footing or pile can bear alone or ii) due to low bearing capacity of the soil.
The piles bear loads both by the frictions gained from their surface and also due to bearing capacity of the soil at the particular depth.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is tension column?
What is bylayer?
the water is flowing through a velocity of 1.5m/s in a pipe of length 2500m and dia 500mm. at the end of pipe a valve is provided. find rise in pressure 1. if the valve is closed in 5 seconds. 2. if the valve is closed instantaneously. take value of c = 1460m/s, pipe to be rigid and bulk modulus of water - 19.692x10' n/sqcm
What things you need to take care of before building a kitchen island?
What is the exception critarea of cube?
How to marking the building
What do you understand by “preset” during the installation process of bridge bearings?
trapozidal
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
primary treatment of sewagw consist of removal of floating materials removal of sand & grit removal of organic materials all above
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
why do we provide haunches in rcc box or underpasses?
What is unit weight of normal concrete?
is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.
within an emergency scenario what are the safe systems of work a coss can setup as part of is duties
