what should be distance between two electrical earthing pit as per i.e.e

what should be distance between two electrical earthing pit
as per i.e.e

Question Posted / manoj bhangale

13 Answers
103124 Views
Badve, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what should be distance between two electrical earthing pit as per i.e.e..

Answer / cottula

this will depends on type of earthing
for plate earthing 6-8mts
pipe earthing 5-8mts
chemical earthing 5mts

Is This Answer Correct ?

3 Yes

12 No

what should be distance between two electrical earthing pit as per i.e.e..

Answer / mrudang

1st rod at 15m
2nd rod at 30m

Is This Answer Correct ?

1 Yes

23 No

what should be distance between two electrical earthing pit as per i.e.e..

Answer / san

20 MTRS

Is This Answer Correct ?

8 Yes

67 No

Post New Answer

More Electrical Engineering Interview Questions

In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.

0 Answers PPIL,

in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.

0 Answers ABB,

Which are Electrical componet and Electronics componet??

2 Answers KarMic,

Car battery + terminal allways biger than - terminal! Why?

2 Answers

i have ht transformer of 142 kva with air cooled facility,having secondary voltage 7850volt, and secondary connected full way bridge rectifier .i faced the problem repeatedly that transformer one coil and rectifier diode of two phase was burnt two times. i checked all the secondary ckt. no any short ckt found,then what will be the cause side

2 Answers Modern Terry Towels,

how many electricity poles are there and what are the names and their sizes.

0 Answers

WHY HOLDING CONTACTOR OF MOTOR STARTER IS CALLED NO VOLT COIL.

3 Answers

25 kva 3 phase dg how many current will take per phase , plssssssss reply me

3 Answers Bharti,

how to select power and control contactor .

1 Answers Bhel,

I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.

0 Answers

1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.

0 Answers Wipro,

what is the difference betweem star connected motor & delta connected motor?

0 Answers

For more Electrical Engineering Interview Questions Click Here