Answer / farooq

if three sensors installed to measure or monitor one process
variable and when two of them give a high or equal to a set
value than an alarm or correcting action can be activated is
called 2 out of 3 automtion.

Answer / senthil

for example,consider the three transmitters are in
service.in logic,the three xtr compare each other value i.e
A&B,B&C,C&A. check the diff of deviation b/w the
comparison.the xtrs showing minimum deviation is taken,from
this the mean is taken b/w two xtrs.this is 2 0f 3.

Answer / ladla

this information is apply for alarm and trip system where
these shows the redundant of the system

Answer / senthil

2 out of 3:
for example:
we use three pressure transmitters in the process line
discharge of a pump.consider the range is ( 0 to 10 bar).we
have a condition that when the discharge pressure is low the
pump has to trip(less than 4bar).
-if two transmitters goes below this value there is trip.
we have deviation alarm,deviation deadband warning also in 2
voting 3 concept.

Answer / gopi

step by step implimentation our logics by using any controller

how to calibrate the radar transmitter for measuring the exact tank level if tank is having agitator moving continiously because due to agitator tank surface level will vary every time.

2 Answers  

why I need valve guard and whats different between guard and positioner ??

0 Answers  

In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?

0 Answers  

What is motion balance principle?

0 Answers  

What is feedback system.

1 Answers   CCIE,

can any one tell leakage class in control valve depend on which parameter and there is any specific table or chart for selection of valve leakage class

2 Answers  

what is the principale of vortex flow meter.

7 Answers   Ambuja, India Glycols,

State four different types of flow measurement.

4 Answers   ADMA OPCO,

A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe

0 Answers  

what do u mean by compensating?in power plant where are compensating done?how level , flow compensated?

1 Answers   TATA,

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers  

Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?

0 Answers