Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / senthil
2 out of 3:
for example:
we use three pressure transmitters in the process line
discharge of a pump.consider the range is ( 0 to 10 bar).we
have a condition that when the discharge pressure is low the
pump has to trip(less than 4bar).
-if two transmitters goes below this value there is trip.
we have deviation alarm,deviation deadband warning also in 2
voting 3 concept.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
What is the purpose of LO Overhead tank in turbines.
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
What are advantages and disadvantage of the ac supply load cell?
In turbine what does term CDP, NI, NH, HSSOC means.
what is the input to be given in digital flow meter during the the calibration time?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
If P will increase then what will happen with PID?
How can measure flow in oil line?which type of transmitter is generally used?
what is cold loop? difference between hot and cold loop?
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
steps for installing orifice plate?
