which type of starter is suitable for single phase motor ?
Answers were Sorted based on User's Feedback
Answer / raj yadav(allahabad)
d.o.l starter use for single phase motor, because it is
small motor and it reach high speed raipidly.so motor are
not take more current for long time
| Is This Answer Correct ? | 15 Yes | 1 No |
Answer / mittal
D O S STARTER IS SUITABLE FOR SINGLE PHASE MOTOR
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / pawan kumar
(D.O.L)Direct on line startar is preperfared in single
phase induction.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / aayushi agarwal
1 phase motors are non self starting
so methods used for starting them are
resistance split
capacitance split a) capacitor start
b)capacitor start capacitor run
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / madhusudhana reddy
DOL(Direct On Line) starter is preferrable as 1-phase
motors have enough Resistance to stop inrush current when
it is just started.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / mohansingh
DOL starter safe and low cost simple operating system
| Is This Answer Correct ? | 4 Yes | 3 No |
What are the basic elements used for modeling mechanical translational system?
Does RCCB do the job of MCB? Lets take 16A RCCB. it trips when residual current exceeds 30mA. does it trip in an over current situation, i.e when current exceeds 16A ??
The undesirable property of an electrical insulating material is
what is the importance of neutral in elctrical system?
4 Answers IOCL, Kharafi National,
DIFFERENCE BETWEEN TRANSFORMER AND CURRENT TRANSFORMER?
what is meant by insulation voltage in cables? explain it?
What is the current flow in 230v ac supply ? What is the current flow in 415v Ac supply ?
IN 3 phase induction motor where we give i/p supply & how its working ?
what is the practical application of full adder circuit?
0 Answers College School Exams Tests,
use of choke in APFC panels
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)