Answer / deepankar

Generally there is no
need of starters for
single phase motors
because they have
very low inertia.
Only an over volt
relay or fuse of
required rating near
main switch should be
suitable.
However if there is no
economical problem
then d.o.l starter may
be used.

how is find out kwh step by step

0 Answers   Voith,

---

plz tel me syllabus and exam date 4 jr executive engg (electrical)

0 Answers   AAI Airports Authority Of India,

---

No load efficiency of transformer is ___________ than full load efficiency

2 Answers   PGCET,

---

what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?

0 Answers  

---

what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator

0 Answers  

---

hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz

0 Answers  

---

In case you don't have coal and salt for earthing, how can you achieve good temporary earthing?

1 Answers   Focus Energy, NHPC, ONGC,

---

how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)

0 Answers  

---

In brushless excitation system how generator field current is measure even if the slip rings are absent?

3 Answers   Adani,

---

What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.

0 Answers  

---

whenever any squirrel or a crow falls on the transformer input line then there is a big explosion and 440 volts of power is being discharged through the neutral line due to which appliances in off mode are also burned.we have earthing for the transformer as well as the bus bar chamber.why is it happening?

1 Answers  

---

Current Transformer's star point must face the protected object for the relay operation?

2 Answers   Siemens,

---