Answer / rahul deo purohit

Short Circuit TEst And open circuit test

Answer / e.saravanan

The General test conducted on transformer is
1.Insulation resistance test
2.Open circuit test
3.Short circuit test
4.Double voltage and double frequency test
5.High Voltage test
6.Resistance test
7.Vector group test
8.Magnetic balance test
9.Break Down Voltage test

Answer / vikramsenareddy

open circuit and short circuit test.
impulse test.
Megger test.

Answer / arya anup

mainly open circuit,short circuit test in order tomeasure
core loss & copper loss. then megger test to check the
insulation level between lv & HV coils.next is high voltage
test to measure capability to withstand impuse of very high
voltages( about 28kV will be applied between HV & Earth)
Then coms double voltage and double frequency test,where
we apply double the rated voltage on to the lv side with
100Hz frequency. this helps to find out insulation problems
between phase to phase.(All tests should be done with oil
inside only)
Oil also to be checked for its break down voltage(shold
with stand minmum 30kV)

Answer / raja

1.OPEN CIRCUIT TEST
2.SHORT CIRCUIT TEST
3.VECTOR GROUP TEST
4.MAGNETIC BALANCE TEST
5.TAN DELTA TEST OF BUSHING CT
6.SFRA TEST- SWEEP FREQUENCY RESONANCE TEST
7.BDV- BREAKDOWN VOLTAGE TEST
8.RATIO TEST
9.INSULATION RESISTANCE TEST
10.STABILITY TEST
11.HIGH VOLTAGE IMPULSE TEST

Answer / gokulkrish

The General test conducted on transformer is

Open circuit test
Short circuit test
Double voltage and double frequency test
High Voltage test

Answer / anbarasu.r

open and short ciruit test

Answer / krupa reddy s

all routine tests and short circuit test

what is corona effect

3 Answers  

What will happen if induction motor is supplied with capacitive load?

1 Answers   NTPC,

what is servo motor and how it works?

0 Answers   Godrej,

How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.

0 Answers  

What is pole slipping relay? When it is operated?

2 Answers   Aditya Birla,

how to calculate the fault in substation

0 Answers  

EXPLAIN THE TRANSFORMER MAINTENANCE?

0 Answers   Enercon, ERT, GEL,

what is feeder bay?

0 Answers  

how much load 15kva dg set can bear

7 Answers  

in three phase 11kv transformer (11kv/433v) input( R,Y,B) output (X,Y,Z,N) the connection as follows 1 phase R -open 2phase y connected to both R and y of input] 3phase B- B what is the output voltage X to N ,Y to N , Z to N

2 Answers   Bescom,

Why do we have 110V, 230V, 415V etc. in electrical transmissions? Why not 100V, 200V,400V?

4 Answers  

definition of transformer

10 Answers