Answer / capseee

Its depends on the cable manufacturer and type of cable
(XLPE/PVC), type of conductor(AL/CU), system
(underground/overhead) etc. Also you have to consider
derating factors like temperature,gap betwwen cables,
distance between cable trays etc(thease details are
provided in the catalogue).

Also the manufacturer provided mv/amp/km details from that
you can calculate the voltage drop. As per standard the
drop at receiving end should be +/- 3% of sending end
voltage.

Answer / m s rana

Its depends on the cable manufacturer and type of cable
(XLPE/PVC), type of conductor(AL/CU), system
(underground/overhead) etc. Also you have to consider
derating factors like temperature,gap betwwen cables,
distance between cable trays etc(thease details are
provided in the catalogue).
Also the manufacturer provided mv/amp/km details from that
you can calculate the voltage drop. As per standard the
drop at receiving end should be +/- 3% of sending end
voltage.
But it is not engineering to run 110kw motor run to DOL
Starter It IS VERY HIGH LOAD & LONG DISTANCE higher losses

When Neutral exceeds or equals the phase current in both single phase * three phase system?

1 Answers  

---

Active power= VI COS FI But incase of leading power factor ( more than unity), may we use other formula ? because the cos fi (value of cos thita) should not be grater than one.

2 Answers  

---

at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?

0 Answers  

---

What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.

0 Answers   Eskom,

---

how freewheeling diode improves the powerfactor

0 Answers  

---

why the transformers are rated in kv not kw?

6 Answers   L&T,

---

HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION

0 Answers   ECCI, EFS,

---

What is corona loss?

2 Answers   PWD,

---

The speed of a dc motor can be controlled by the variation of 1. armature voltage. 2. field current. 3. armature circuit resistance. 4. angle of brush shift. Which of the statements given above are correct? (a) 1,2 and 3 (b) 2,3 and 4 (c) 1,3 and 4 (d) 1,2 and 4

1 Answers  

---

difference between alternator & GENERATOR

4 Answers  

---

What size cable is used for HT cable to the transformer of 630kVA, and the supply voltage is 11kV

2 Answers  

---

Why does inductor is connected to dc supply? or what is the role of an inductor when connected to DC source?

3 Answers   TCS, TRR,

---