why we use isolation transformer?
Answers were Sorted based on User's Feedback
Answer / suresh apgenco
isolation transformers are used to isolate faults which
occur on the primary side not to transfer to secondary
side.
Is This Answer Correct ? | 14 Yes | 0 No |
Current Capacity of 55sqmm & 80sqmm conductor
1.4 What is meant by CT knee point voltage and how would you determine it
what are clipper and clamper circuits?
why u want to work in sail/ntpc as u r already in an it company where life is good, good environment no much tensions etc?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
what is gridrotor resistance starter
when we increase load , current drawn from source also increases why ?
How to calculate the size of the conductor for particular load
how to calculate the capacity of CT operated LT trivector meters on a particular distribution transformer.
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
HOW DEFINE THE IP FOR ELECTRICAL EQUIPMENT AND WHAT IS THE IP OF PANELS USING IN HAZARDOUS AREA ?
why Lightening Arrester Probe sharp at Top of telecom tower.