Answer / lakmal

when running the motor in star cnnection it will take high
current.but it running in delta it will take low
current.why P=TW .P=power,T=torque,W=anguler velosity

Answer / muhammad tahir khan

because instart for motor, we need high current ,for that
purpose we use delta instead of star. Another reason is
that delta connection control the harmonics and increas the
motor life, also we can use star but by using star the
efficency of moter will decrease.

Answer / robbin singh

The most of HT motor are in star conection and some of
slipring motor are also in star conection.

Can i replace Earth leakage relay to the faulty Earth Faulty Relay

0 Answers  

---

why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?

0 Answers   Siemens,

---

Can CT Secondary left open circuited and why(reason)?

5 Answers  

---

WHEN I AM CONNECTIN TWO ELCB IN PARALLEL.ONE ELCB TRIPPED...HOW IT HAPPEND??

5 Answers  

---

ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]

0 Answers  

---

In a single how much maximum current and watts using

0 Answers  

---

Can we use 1.1x 2 split air-conditioning at a same time in 2kw power loadar

1 Answers  

---

what is 2 phase motor?

4 Answers  

---

What current position are you holding in your current company?

0 Answers  

---

What is the function of Lightning Arrester & Wavetrap in Power system ??

18 Answers   ABB, Bhel, Energy Infratech, Infosys, NTPC,

---

how the speed of the gets motor regulated. does it draw the same current on the all speed level.

0 Answers   Danko,

---

how terminal voltage increases when load is capacitive (leading pf load)? (explain practically what is happening, not using phasor diagram

1 Answers  

---