Answer / k.c.bhanu

In an industry the main meter CT's ( highly insulated as
per High voltage standard)primary windings are connected
directly to HT voltage(11KV/33KV)& secondary winding to the
Trivectometer. the check mteres & its CTs are commonly
installed with LT/ low voltage system of Consumer.
The Main PT (HT side) are designed 11KV/110volts or
33KV/110volts the primary windings are connected to the
High voltage & the secodary windigs out put (110 volts)are
connected to the Trivectometer.

Answer / k.prakashchandra

In case of gen stations both are identical , there is no
difference at all

what is the temperature rise test? explain in brief.with formula.

1 Answers  

---

I need bhel electrical test pattern & paper

0 Answers  

---

why lightning arrester and other equipment earthing conneting from same earth bar ?

1 Answers  

---

how to synchronize 3 phase slip ring induction motors of different ratings.

0 Answers   GMR,

---

what is the opencircuit tes &short circuit test in transformers ,why you need this test, in poen your connecting which votmeter why?

1 Answers  

---

---

losses in transmission lines ?

0 Answers  

---

what will happen if the frequency supplied is more than the frequency of the instrument...?

3 Answers  

---

How REF protects transformer alone? explain with diagram.

0 Answers  

---

How calculate the MTA in relay?

1 Answers   Unicharm,

---

A current of 2A flows for 10 hour through a 100 ohm resistor. The energy consumed by the resistor is:(a) 0.5 kWh(b) 4 kWh(c) 2 kWh(d) 0.02 kWh

3 Answers  

---

PLC Based Process Automoation Panels?

2 Answers  

---

What are all the points to be checked for a newly re-winded motor before installation

1 Answers   Cisco,

---