Interested to Buy Any Domain ? << Click Here >> for more details...
Hi Friend I am used multimeter to measure the voltage
between R Phase(SS1) to R Phase(SS2). In SS1 is connected
with UPS loads. But I am getting voltage between these 2 R
Phases. Please give some idea friend
- 0 Answers
- 2165 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
How is the gain affected by the introduction of feedback in a control system.
How we can come to know the substation range,without go through any name plate ?
what are the deffects for failure of PLC?
different between circuit breaker & switchgear & relays
Y phase plates are used in transmission line??? what is there need???
in a transmission line if the load is suddenly increased in the receiving end of the system the phase shift will ?
What is resonant frequency?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
WHAT IS MEAN BY MAGNETIC LOCKING
wht is meant by sh6
CAN A CD/CLOCK RADIO WITH 110V 60HZ WORK ON A 110V 50HZ FEED.
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
