Answer / murthy

0.5 to 0.6 Volts

Answer / neranjanr

Usualy Mono Crystalline or polycrystalline solar cells have open cell voltage slightly above 0.6V. But, when loaded (a load is connected) it will come to 0.5V~0.6 V.

Some special cells have higher voltages like 0.7V (eg: Panasonic HIT/ LG MonoX NeON)

In secondary transmission i.e., in distribution side, supply for homes are connected through different phases in order to balance the 3 phase load. But in practical we saw nearby house doesn't have power due to single phasing. But other two phases give supply. How it's possible? it doesn't make "single phasing"?

1 Answers  

---

what is pressure relief valve?where it is used????

4 Answers   Mecon,

---

what is first pole to clear factor ?

3 Answers  

---

in case of OC+EF relay, how the burden is divided/calculated/shared by the CTs in case of normal (healthy condition) and during fault conditions.? three coils of OC & ef coil is conected in residual connection across the three CTS.

1 Answers  

---

Why is the electric shock from the DC supply is more dangerous than the shock from AC supply.

8 Answers   IBM,

---

How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.

0 Answers  

---

Why only plate(copper) Earth pit given for neutral earthing? why not pipe(G.I) Earth pit?

1 Answers  

---

WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??

14 Answers   Dubai Group, Saudi Delta Groups, Savitha Electricals,

---

I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)

1 Answers  

---

Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards

0 Answers  

---

acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO

0 Answers  

---

How feedback transformer works to feedback power in Slip Power Recovery System

2 Answers  

---