1. The DC generaror,s induced output emf is connected with a DC motor(as

1. The DC generaror,s induced output emf is connected
with a DC motor(as load). when increasing the load of
the motor by using brake drum or any way.
what are the parameters will changes in both motor and
generator(voltage, current, resistance, frequency,
speed, torque, power, flux etc...)

2. Similarly for AC generator and AC motor
3. similarly if using DC batteries instead of DC generator,
What happens?

Question Posted / n.dhanasekaran

0 Answers
2304 Views
IBM, Kirloskar, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

which frequency is to be selected for measuring earth resistivity

1 Answers MSETCL Maharashtra State Electricity Transmission Co Ltd,

how much watts the computer will takes

2 Answers

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers

in 4 pole lap wound dc motor one brush is disconnected then what result in new voltage if its voltage is v volts power is p watts current is i amp

1 Answers GATE,

Why do we need interlocking in a HT metering or Ring main unit switchgear?

0 Answers

we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes

0 Answers

how is the leakage current flow only through guard wire (when guard wire is connected in the circuit)????

2 Answers

when we are going to higher voltage level in substations why we are using Sf6 circuit breakers instead of Vacuum circuit breakers.

3 Answers

If there is 25 hp motor,which type of starters we can us? why?

7 Answers

why transformer rating is always in KVA

7 Answers GNG, NTPC,

Is it possible to make 0.75KW motor earthing from MCC panel by using the 1.5 SQMM, 4 core cable, means 3 core for 3 Phases & 1 core for Earth terminal?

4 Answers

Why use prefer Dc drive in place of Ac drive for kiln Operatio in Cement Plant?

4 Answers Orient,

For more Electrical Engineering Interview Questions Click Here