how will you segregate the alarm levels in alarm management system during factory Acceptance Test

0 Answers  

---

What is three element in drum level?

0 Answers  

---

what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com

0 Answers   Bosch, Eskom, Sabic,

---

this site is owned by an nonsense

0 Answers   Bhel, Prolific,

---

WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL? INSTEAD OF 4-20mA.

6 Answers   Hindustan Unilever Limited, Yashmun Engineers,

---

What is the relation between electronics & instrumentation

2 Answers  

---

what is flow and flowrate? definate and diffrentiate it? pls post a valid ans thanks in advance

2 Answers   Qatar Gas,

---

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

---

What is difference between scada and virtual instrumentation?

1 Answers  

---

How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?

0 Answers   Matrix,

---

Why thermo wells are used?

1 Answers  

---

in mass flow meter what is drive friquancy ?

0 Answers  

---