The document / drawing that is primarily used in depicting the “Bill of Mate

The document / drawing that is primarily used in depicting the
“Bill of Materials (BOM)” of piping system is the

Question Posted / slyabi

2 Answers
4961 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of pi..

Answer / donnie

The Isometric is used for BOM and Installation.

Is This Answer Correct ?

1 Yes

0 No

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of pi..

Answer / guest

The document which incorporate the "BOM" and which is also
used for the installation guide for piping is "installation
diagram" or "hook-up diagrams"

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

Can any body help me,The GE Mark V control system is windows based or Dos based?

3 Answers

What is difference between converter & transducers?

4 Answers

1. How many output signals do wew have in process control? 2. Could you write down the names of the pre-commissioning and commissioning stage test instruments and explain them (more than 5 items)? 3. What is the first step to commission a transmitter on service? 4. What is RTD? 5. Find the output value in MA of a temperature transmitter (RTD Type) at 120degree celius? 6. What is the O/P signal of a pneumatic transmitter? 7. What is the O/P signal of an elctronic transmitter? 8. What is the close loop and open loon?

4 Answers

Explain types of valves?

0 Answers

given a processor batch of 1000 resistors moving on the conveyor belting in a large factory. the resistors is value at 10k ohms each but when the resistors reach the quality control, some of the resistor has been rejected caused by failure in manufacturing.the high quality measurement is used to determine the failure. describe the instrumentation terminology in measurement of a system above with explaining the important in:- -reliability -sensitivity -repeatability -precision -range -resolution -linearity -hysteresis -error -accuracy (answer must related to the scenario above)

0 Answers

why we are using pnp npn for sensors is there any other type?

1 Answers CGL,

3. Differentiate between ultrasonic flowmeter and radar type flow meter.

0 Answers

Can 2 transmitters be connected to Integral orifice meter taps? Does an integral orifice comes with 2 set of taps?

1 Answers

Can I put my meter across an RTD to check it safely witout tripping the equipment when it is connected to an monitoring device eg.RTD module or IQ 1000

1 Answers

what is datum line?

4 Answers

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers Process Control Technologies,

how many types of spped sensors n vibration sensors?their basic principle n connection?

0 Answers IOCL, ITC Infotech,

For more Instrumentation Interview Questions Click Here