What do you need to consider when installing a flowmeter

Question Posted / ran ire

2 Answers
4025 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What do you need to consider when installing a flowmeter..

Answer / karthik s

first we need to measure the pipe line length and diameter and flow rate of the liquid.Then we decided to which type of flow meter is required.

Is This Answer Correct ?

5 Yes

3 No

What do you need to consider when installing a flowmeter..

Answer / rakesh bawankar

Its about installation so we have to check direction of flow first them upstream and down stream length of pipe .

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Why not come out analog output in ABB EL3020 when display show correct value

0 Answers

How to do manual mapping in radar type level transmitter?

2 Answers

in the boiler in the main steam line and its bypass line and the startup vent vales are only motorised valves why cant we use other types of valves such as pneumatic.

3 Answers

What the basic of communication?

4 Answers Schneider,

Generally in which location ( JB or IO card or DCS) the thermocouple compensation is done.Also where they measure the atmosphere temp ( for compensation) in JB OR DCS panel? How they compensating that atmosphere temp? is any circuit for that ( like in rtd wheatstone bridge)?

3 Answers

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers OPaL,

Which boiler is use in power plant

1 Answers Jindal,

Explain the working principle of lvdt?

0 Answers

hi vishok this is noor plz tell me what type problems will occured i use T/C in the place of RTD in (FEED WATER TANK),plz send ur e-mail address to my ID (mail2noor.hyd@gmail.com)

6 Answers

How to do calibration of magnetic flowmeter

1 Answers Kharafi National,

How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System

0 Answers

WHEN BOTH WIRES OF THERMOCOUPLE R SHORTED WHAT IS THE OUTPUT THE TEMP ARE 0,30,250,320

13 Answers

For more Instrumentation Interview Questions Click Here