Answer / ankitbhagat9

Water tube boiler

why the derivative in PID is always set to zero?

3 Answers  

---

How to interfacing microcontroller with a DC motor

0 Answers   JJ Tech,

---

How earthing can be checked????

0 Answers  

---

What should be hight of CONTROL panel for access & OPERATION What is BIS & INDIAN STD for SAME?

3 Answers  

---

Can we use PLC in Hazardous Area?

2 Answers   MNHG,

---

units of pressure,flow, level,temperature? principle of pressure gauge? calibration of pressure tx., level tx., temperature tx.flow tx.? description of two wire ,three wire and four wire R.T.D.? WHAT IS INPUT AND OUTPUT OF TX.? WHAT IS INPUT AND OUTPUT OF R.T.D. AND THERMOCOUPLE? WHAT IS HOT LOOP AND COLD LOOP? WHAT IS INPUT AND OUT PUT AND OUTPUT OF D.C.S. AND P.L.C.? PRINCIPLE AND WORKING OF HART? WHAT IS PNP AND NPN PROXY? CALIBRATION OF PRESSURE ,LEVEL ,FLOW SWITCH? DESCRIPTION OF FIELDBUS FOUNDATION? WORKING OF SOV.?

2 Answers  

---

Tell me about PID Tuning and what is PID.

4 Answers  

---

what is the principle of ultrasonic flowmwter and radar type flowmeter?

4 Answers  

---

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

2 Answers  

---

give me all the details about the interview and which type of question being asked

0 Answers   Jindal,

---

What is the difference in clamp on type and inline type ultrasonic flow transmitter.

1 Answers  

---

IF ASK IN THE INTENVIEW WHAT TYPE OF BMS YOU USE?

1 Answers  

---