We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

Question Posted / vivek_5530

0 Answers
1669 Views
OPaL, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Instrumentation Interview Questions

Why would an Engineer consider combining FEEDBACK and FEEDFORWARD control in some applications?

4 Answers Jindal,

Can anyone explain in a simple way the difference between DCS and PLC?

7 Answers Honeywell,

Explain about the leakage class of the control valves

0 Answers CCIE,

How to find out turn down ratio of Pressure transmitter?

1 Answers

pressure gauge measure static pressure or dynamic pressure?

3 Answers

how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?

0 Answers

In Safe Guarding test what means by "Failed to Danger" ?

0 Answers Optimal,

what is consistency transmitter and describe its working?

1 Answers Emami,

how to know power plant process with corresbonding laws&thoeries

1 Answers Bhel,

What is the purpose of LO Overhead tank in turbines.

0 Answers ADMA OPCO,

What is the function of a diaphagram

5 Answers

How can i solve the problem of ROSEMOUNT 5300 guided wave level transmitter of full range? For more clearfication , another guided wave level transmitter VEGA brand have the same problem and i solved it by drain the champer from water and make "false signal suppretion" from transmitter push buttons it's configuration to tell the transmitter to avoid any built-up signal ,,, so my question how can i avoid the problem that rosemount read full range while the champer empty or any other ????

1 Answers

For more Instrumentation Interview Questions Click Here