Answer / dr.atul bansod

Elevation is given for compensation of natural sag of heavy rotors.Steam turbine manufacturer submits a document known as deflection curve for rotors. On that curve '0'point is specified (any bearing) and other bearings ar kept on different elevation with reference to this "0" refereed bearing.

Answer / rayudu thota

While rotation high speed shaft of gear box will lift by low speed side shaft due to the load on high speed shaft
Then it will come in to centre line after rotation.

Answer / amit singh

It will damage the shaft coupling and more even dangerous in running condition & JOP lifts the shaft not by weight u fool.

what is CT saturate?and which effect on CT after its saturate?

4 Answers  

---

thermal power plants in steam using inlet of turbine.inlet of turbine pressure and flow is same as boiler feedpump why not use direct to turbine?

6 Answers   IBPIL, JSW,

---

what is restricted earth fault explain in details

0 Answers   Greenko, JSW,

---

.What is drip and drain.

2 Answers   NPTI,

---

what is the basic use of power plant in equipment

0 Answers   JK Diary,

---

whats plant?

1 Answers   Bhavini,

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

In a thermal power plant ID Fans running with full load but boiler load is only 80 % give reason ?

9 Answers   Essar, Prumatech, Tata Power,

---

During shutdown of Steam Turbine,How do we cross the critical speed?

7 Answers   OPG, Power,

---

Difference between electrical and electronics?

7 Answers   Power Plant,

---

line safety is not opening but drum safety opens what to do?

3 Answers  

---

How to calculate air to fuel ratio in boilers

1 Answers  

---