thermal power plants in steam using inlet of turbine.inlet
of turbine pressure and flow is same as boiler feedpump why
not use direct to turbine?
Answers were Sorted based on User's Feedback
Answer / devinder singh
BECAUSE STEAM TURBINE IT IS A DEVICE WHICH CONVERT HEAT ENERGY INTO MECHANICAL ENERGY SO WE HAVE REQUIRED SUFFICIENT HEAT , IT WILL COME FROM STEAM. BUT IN ANOTHER WAY WE HAVE DIRECT WATER USE IN HYDRO POWER PLANT BUT WE CANNOT PLACE HYDRO POWER PLANT IN ANY WHERE SO .....
| Is This Answer Correct ? | 8 Yes | 3 No |
Answer / chanchal rajput
Because at that pressure steam has a energy in the form of
temperature and in turbine it expand ,in expansion we get
work in form of rotating energy, but at the same pressure
water has no heat energy so it can not expand in turbine
means no work output.
| Is This Answer Correct ? | 6 Yes | 2 No |
Answer / raja
U need a feed pump of the size of the alternator u have, to make this possible. In other words the alternator can only produce the power of your feed pump only.
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / mayur mukaty
Specific heat of Water and super heated steam is different. turbine design Is so that it give max output with minimal Heat energy. As well Steam turbine Operation is base upon conversation of Thermal energy to Kinetic Energy. So come to point when We Direct put Water in to the turbine is Power consumption is so equally to Turbii Output that why its not fisible. Another thing is that compressibility factor but i did not go on that concern because It too long. term
| Is This Answer Correct ? | 0 Yes | 0 No |
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
What is indipendant power plant
What happens if air is present in LPH and HPH.
what is the difference between kg/cm2 to MMWC
Why reheater is not used after IP turbine.
why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
what is the basic use of power plant in equipment
What will happen if the Air Preheater is placed before the Economiser?
6 Answers Bhel, KSPL, Tata Power,
Where is the pressure reduce valve in the power plant
What are the motors used in a thermal power plant? (With type and ht/lt) What voltage levels are used in a thermal power plant?
what is voltage transformer explain in details
5 Answers Khulna Power, NCC, Reliance Power,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)