Answer / mahesh

5/2 means, 5ports/2ways.
Out of 5 ports, 1 is pressure Inlet port and 2 others are cylinder ports providing pressure to the double acting cylinder and one/two outlets are exhaust pressure from the cylinder.

Answer / harshal

It is dcv ...direction control valve
5/3 means 5 way 3 positions....related to pneumatic supply passing through way with position of plunger in valve

Answer / kpsingh

No of port:5 and No of Position (Plunger):2.Five ports means, 01 i/p (air supply in), 02 o/p (one o/p port will send air while other remain close and the function will change when coil will energize) and 02 exhaust port (will exhaust the air when coil will de-energize).Two position means plunger is either up (openes the line) or Down (closes the line)

Answer / yogendra sahu

5/2 it means 5 port 1 inlet 2 outlet 2 exst
/2 it means 2 position open or close

Answer / vinay

5/2 means 5means to give or take air and 2means giving input power 2 wire.

Why in turbine used two critical speed band ?

1 Answers   Ankit Metal Power,

what is proportional & what is proportional band

1 Answers   Nimir,

Technician A says that a fuel tank sending unit will have a high resistance only when the tank is full. Technician B says that its resistance when the tank is full depends on whether the sending unit is designed for use with a bimetallic gauge or with a magnetic gauge. Who is correct?

3 Answers  

When we will do simulation for I/P?IF WE DO SIMULATION through which way either series or parallel?

1 Answers   TVS,

what is LAS in foundation fieldbus protocol?

1 Answers  

need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate

0 Answers  

what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail

0 Answers   Process Control Technologies,

What is the maximum distance limit of 4-20mA and 0-10V DC standard signal transmission ?

3 Answers   BARC, ME,

I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.

0 Answers  

Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function

0 Answers   Reliance,

how to calibrate transmitter

3 Answers   Sabic,

WHAT IS A CALLIBRATION? WHAT IS MEEAN BY LOOP CHECKING INCLUDES PRESURE, THERMOCOUPLE,TT,DT?

5 Answers